HyperX Savage 4GB 2400MHz DDR3 Non-ECC 240 Pin CL11 XMP DIMM PC Memory Module

  • HyperX Savage 4GB 2400MHz DDR3 Non-ECC 240 Pin CL11 XMP DIMM PC Memory Module
    HyperX Savage 4GB 2400MHz DDR3 Non-ECC 240 Pin CL11 XMP DIMM PC Memory Module
    Default Category > Memory > Computer Memory > PC RAM
    HyperX HX324C11SR/4 is a 512M x 64-bit (4GB) DDR3-2400 CL11 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA components per module. Each module supports Intel® XMP (Extreme Memory Profiles). Each module has been tested to run at DDR3-2400 at a low latency timing of 11-13-14 at 1.65V. The SPDs are programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. Each 240-pin DIMM uses gold contact fingers. Key Features - JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply - VDDQ = 1.5V (1.425V ~ 1.575V) - 800MHz fCK for 1600Mb/sec/pin - 8 independent internal banks - Programmable CAS latency: 11, 10, 9, 8, 7, 6 - Programmable Additive Latency: 0, CL - 2, or CL - 1 clock - 8-bit pre-fetch - Burst Length: 8 (interleave without any limit, sequential with starting address ??000? only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS) - Bi-directional Differential Data Strobe - Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%) - On Die Termination using ODT pin - Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C - Asynchronous Reset Specification - CL(IDD): 11 Cycles - Row Cycle Time (tRCmin): 48.125ns(min.) - Maximum Operating Power: TBD W* - UL Rating: 94 V - 0 - Operating Temperature: 0C to +85C - Storage Temperature: -55C to +100C
    £49.99
    + Add to my saved list

    Visit Store »

Add a Review/Comment

 

Similar Products